Journal of New Technology and Materials
Volume 1, Numéro 0, Pages 39-43
2011-12-05

Realization And Study Of Zno Thin Films Intended For Optoelectronic Applications

Authors : Herissi L. . Hadjeris L. . Moualkia H. . Abdelmalek N. . Attaf N. . Aida M. S. .

Abstract

The objective of this study is the realization of zinc oxide (ZnO) thin films intended for optoelectronic applications. For this purpose, thin films were prepared by spray pyrolysis technique from zinc acetate solutions of different molarities (0.025 M, 0.05 M and 0.1 M) used as precursors on Si and glass substrates heated between 200 and 500 °C. The nozzle to substrate distance was varied between 20 and 30 cm. Structural, optical and electrical properties of the films have been studied. The results indicated that the films deposited were transparent in the visible region, well adherent to the substrates and presented surface roughness. All samples were polycrystalline in nature, having hexagonal würtzite type crystal structure. A (002) preferred orientation was observed at 450°C and a 0.025M molarity. The optical energy gap measured was about 3.3 eV. The refractive index values presented small variations with the deposition conditions and were located between 1.8 and 2.0. The electrical properties showed that the samples are natively n‑type semiconductor and the electrical conductivity at room temperature varied between 10-5 and 102 (Ω.cm)‑1.

Keywords

thin films, semiconductor, band-gap, refractive index, electrical conductivity, optoelectronic.

Investigation And Comparison Of Electrical And Optical Properties Of Rf Sputtered Cu Doped Zno And Zno/cu/zno Multilayer Films

Zaabat Sara .  Challali Fatiha .  Chakaroun Mahmoud .  Boudine Boubaker .  Boudrioua Azzedine . 
pages 45-50.


Realization And Calibrating Of A Dip Coater For Thin Films Deposition

Ghanem S .  Telia A .  Benalla H .  Benmounah S . 
pages 9-13.


Fabrication, Structural And Optical Characterization Of In Doped Zno Thin Films Prepared By The Colloidal Method

Medjaldi M. .  Touil O. .  Zaabat M. .  Boudine B. .  Halimi O. .  Sebais M. . 
pages 77-80.